:: CNC CONTROLS ::
| Touch 2000 |
|---|
Specs:
- Automatic machine home
- One touch tool offset entry
- Inch/metric operation
- Constant surface speed selection
- Tool table Gear range selection
- 35 programmable machine stops for X and Z travels Radius and Fillet function
- Automatic teach mode
- Spindle CW/CCW/Stop
- Chamfer function with taper
- Automatic threading
- Taper threading
- Automatic roughing cycles for inside, outside and face turning
- Line and arc moves
- Automatic corner radius and chamfer
- Drilling cycle
- Peck drilling cycle
- Boring cycle
- Rigid tapping cycle
- Tool change page
- Parameter page
- Event repeat cycle
Note1
Note2
this is where additional content would go if it was needed -- perhaps a small discription of the information provided on this page.
Note2
this is where additional content would go if it was needed -- perhaps a small discription of the information provided on this page.